Tap the blue “i” and write down the number after 'Router'. Gateway: On iPhone, connect to the network you are planning on syncing with in Wi-Fi settings. IP range may be only 2-100, so if using 201 doesn't work, try a number between 2 and 100. if the gateway is 192.168.1.x, use 192.168.1.201, if gateway is 10.0.0.x, IP would be 10.0.0.201) The goal is to use an unused IP address and pinging an IP address may be helpful in determining if an IP is in use or not (see below). IP Address: Use the first three numbers from the gateway and 201 for the 4th number (e.g. How to Determine the Information Required for an Advanced Sync: Put in your Wi-Fi password and the additional information required.

When asked to input your password, please select the 'Advanced' at the top. Step 4: Once it is flashing red and green, select 'Add a new SkyBell' in your app and follow the on-screen instructions to re-sync your device until after you have selected your network. Within a minute or two, your SkyBell will be flashing red and green. During this time, please delete your SkyBell device from within the SkyBell app if you have not already.

Step 3: Once you see the LED flash yellow, please release the SkyBell button. The LED will flash rapid green > red and green > blue > yellow.

Step 2: After verifying that information, hard reset the SkyBell by pressing and holding the SkyBell button. Step 1: Determine the information required for Advanced Sync with the instructions below.

Skybell hd won't sync